![]() 2 When the transmitter is turned on, the receiver is turned on. If not, power down the transmitter and turn it on once again. The RF output confirmation display of the transmitter is confirmed. 1 After the TM-FH module has been installed into the transmitter, using the aforementioned steps, turn on the transmitter. Do not perform the linking procedure with motor's main wire is connected or the engine is operating as it may result in serious injury. WARNING After the linking is done, please cycle receiver power and check if the receiver to be linked is really under the con- trol by the transmitter to be linked. Should you wish to re-link them, or if you have purchased a separate receiver and would like to link it to this TM-FH, please adhere to the following procedure. Additionally, it is important to note that this TM-FH and R2006GS receiver set has already been linked by the factory. Once the linking is done, the ID code is stored in the receiver and the re-linking is not necessary unless the receiver is to be used with a different TM-FH module. In order to start operation, the receiver must be linked to the respective TM-FH's ID code. ![]() Easy Link Each TM-FH transmitter module has an individually assigned unique ID code. Doing so may degrade the quality of the RF transmission to the model. If your flying style creates this situation, easily move the antenna to correct this situation.Ģ Please do not grasp the transmitter's antenna during flight. As such, the antenna should not be pointed directly at the model. Antenna of TM-FH 1 As with all radio frequency transmissions, the strongest area of signal transmission is from the sides of the TM-FH transmitter module's antenna. 3 Next, with the transmitter's power off, remove the existing transmitter module and install the TM- FH module with care so that the connector pins of the transmitter won't be damaged. ![]() Please consult the respective owner's manual for your particular transmitter for information on how to do so.Ģ While it is unlikely that the existing transmitter antenna will interfere with the radio frequency transmission of the TM-FH, we suggest removing it from the transmitter if possible as a precaution. 1 Ensure that the transmitter is set to the PPM (pulse position modulation) mode. In order to navigate out of this carousel please use your heading shortcut key to navigate to the next or previous heading.Īttachment of the Module CAUTION Be sure to turn off the power of the transmitter before you install or replace the module. This shopping feature will continue to load items. ![]() Throw: When speaking of a control surface (such as an elevator or aileron), the. 5 Reversing (servo reversing): ˇ ˝ ˇ ˜ =
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |